STEERING / FRONT SUSPENSION
Suspension Free Hanging With
IFS Shocks Installed
- To adjust, lengthen or shorten appropriate lower radius rod until top of bar is within specified camber
distance. Measurement should be taken from top of alignment bar to top of ski pivot bushing hole in
spindle (bushing removed) . Radius rod must be re-attached to trailing arm before measuring.
CAMBER - ACCEPTABLE RANGE
NOTE: Measure from top of bar to the top of the
hole.
EXAMPLE:
Specified Camber = 3/4 (19mm)
Specified Tolerance =
Acceptable Range = 7/16 - 1 1/16 (11-27mm)
See page 6.12 for specific applications
6.16
CAMBER INSPECTION
All Models - Elevate Front End - Shocks Installed
Typical CRC Shown - Style varies by model
Radius Rod End
Jam Nuts
Attaching Bolts
Refer to specifications for:
SIFS type
SSpecified amount of camber
5/16 (8mm)
Upper radius rod
Lower radius rod
Measure Here
Range
Specified Camber