Table of Contents
Advertisement
Select Button
To use either of the
features that require the
Select button (
Select Ring and Ringer Volume
To select a personalized
ring
To adjust ringer volume
if necessary (speaker
must be off)
1
Choose either of the following after pressing
Select
)
Select
1
Press
2
Press
3
Continue to press
8 ringing patterns
4
When you hear the desired ringing pattern, press
Select
Note: If you receive a call, go off-hook, or lose power
during selection, process is interrupted and you must
begin again. If you lose power after selection, you
will also have to select your ring pattern again.
1
To raise the volume, press the right half of the
Volume control button labeled
volume, press the left half of the Volume control
button labeled
:
Drop
Press
to initiate a self-test of your voice
Test
terminal lights and ringer. For procedures, see
''Self-Test'' in this section.
Conference
Press
to select one of 8 personalized
Ring
ringing patterns for your voice terminal. For
procedures, refer to ''Select Ring'' in this section.
(while on-hook)
Select
Green light goes on
Conference
Ring
Green light next to
Current ring pattern plays and repeats every
4 seconds
Conference
again
Your new ring is set. Light next to
goes off
flutters
Select
to cycle through all
Ring
. To lower the
.
Select
17
Advertisement
Table of Contents
