Select Ring (And Ringer Volume) 2 - AT&T 8434 User Manual

Remember that you can use the Reset Speakerphone feature only if your voice
terminal is set for the Speakerphone feature (as opposed to the Speaker feature).
To adjust the
speakerphone to the
surrounding room
acoustics
Select Ring (and Ringer Volume)
To select a
personalized ring
To adjust the volume of
the tone ringer on your
voice terminal
1 Press [ ]
Select
Green light next to [
Press [ ]
2
Speaker Reset Spkr
Green light next to [
Green light next to [
intermittently
You hear a series of tones as the speakerphone
performs an acoustic test of the environment.
When the tones stop, your built-in speakerphone
is ready for use.
1
While on-hook, press [
Green light goes on steadily
2 Press [ ]
Conference Ring
Green light next to [
ringing pattern plays and repeats every 4 seconds
Display shows [
(x will be a number from 1 to 8)
3
Continue to press [
Conference Ring
ringing patterns
4 When you hear the desired ringing pattern,
press [ ] again
Select
Your new ring is set; green light next to [
goes off
Note: If you receive a call, go off-hook, or lose power
during selection, process is interrupted and you must
start again. If you lose power after you have selected
your personalized ring, you will have to select your
ring pattern again.
To raise the volume, press the right half of the
1
Volume control button labeled [
to lower the volume, press the left half of the
Volume control button labeled [
Display shows [
(There are 8 possible volume settings. On the
display, 1 arrow is the lowest setting, and 8 arrows
is the highest setting)
] goes on steadily
Select
] goes off
Select
] flutters
Speaker Reset Spkr
]
Select
] winks; current
Select
]
Personal Ring #x
] to cycle through all 8
] ;
]
Ringer L > > > >
]
Select
]
H
22