Surface Housing With Post Mount - Secura Key ENTRACOMP 26SA User & Installation Manual

2. Mount plate to wall using appropriate fasteners. Use at least
four of six holes provided.
3. Connect power and control lines to wire leads provided as
per the wiring instructions.
4. Plug connector into reader board.
5. Place ENTRACOMP
top edge first, centering housing on retaining tabs. Secure
housing to plate at bottom using one 6-32 x 3/8 security
screw provided or equivalent.
6. Lock cam lock.
SURFACE HOUSING WITH POST MOUNT ADAPTER
(See Figure 6)
1. Mount post mount adapter (optional) to post (not supplied).
Screw 1 1/2 inch pipe coupling on rear of post mount adapter
plate to post until almost tight, stopping when reader cover is
at top (12 O'clock). A small tack weld is strongly suggested
to keep the housing from rotating on post.
2. Apply 1/8 inch bead of silicone sealant around rear perimeter
surface of mounting bracket gasket.
3. Press plate against adapter and secure with four 10-32 x
5/16 pan head screws (provided).
®
26SA housing against mounting plate,
Secura Key • 16