Remote Open; Securelay - Secura Key ENTRACOMP 26SA User & Installation Manual

REMOTE OPEN (REX). Connect the Brown and orange wires to
any Normally Open switch. Closing this circuit will activate the Latch
Relay for the number of seconds you have selected when you set
the Latch Timer.
TM

SecuRelay

. The SecuRelay
separately for use with ENTRACOMP
firmware version 4.0 or later. SecuRelay
control circuit to be remotely located so that attacking the 26SA will
not open the passageway on the SecuRelay
3 pin connector must be cut off and the following connections must
be made.
SecuRelay™
RED WIRE
VIOLET WIRE
BLACK WIRE
N/A
NOTE: Remote Open must be disabled if SecuRelay
TM
from Secura Key may be purchased
ENTRACOMP
RED WIRE (PIN 7)
YELLOW WIRE (PIN 3)
BROWN WIRE (PIN 10)
CONNECT GREEN WIRE (PIN 5)
TO BROWN WIRE (PIN 10)
TABLE 2
Secura Key • 14
®
26SA units which have
TM
allows the lock/gate
TM
wiring harness. The
®
26SA
TM
is used.