Validating A Block Of Cards - Secura Key ENTRACOMP 26SA User & Installation Manual

Example: Validate card number 100.
Place the "1" card on the TOUCH CARD
the "0" card on the TOUCH CARD
the "0" card on the TOUCH CARD
"VALID" card on the TOUCH CARD
1
VALIDATING A BLOCK OF CARDS. To validate a block (continuous
sequence) of cards, place the sequence of cards representing the first
card number of the block on the TOUCH CARD
"*" (THRU) card, then the sequence of cards representing the last card
number of the block, and then place the "VALID" card on the TOUCH
®
CARD reader plate.
Example: Validate cards 5 thru 225.
NOTE: After a block Validate or Void is complete, the LED will turn
Green. Then the reader will beep and the LED will turn off.
Place the "5" card on the TOUCH CARD
*
the " " (THRU) card on the TOUCH CARD
place the "2" card on the TOUCH CARD
place the "2" card on the TOUCH CARD
the "5" card on the TOUCH CARD
"VALID" card on the TOUCH CARD
5
+ 0 +
*
+ + 2
Secura Key • 6
®
reader plate, remove it and place
®
reader plate, remove it and place again
®
reader plate, remove it and place the
®
reader plate, and remove it.
0 + VALID
®
reader plate, remove it and place
®
reader plate, remove it and
®
reader plate, remove it and again
®
reader plate, remove it and place
®
reader plate, remove it and place the
®
reader plate, and remove it.
+ 2 +
® reader plate, then the
5 + VALID