IPI ELECTRONIC SYSTEM WIRING DIAGRAM (BP7 SERIES)
WHITE
CPI/IPI
SWITCH
REMOTE RECEIVER
(OPTIONAL)
+ ON
REMOTE
- OFF
AC/DC
POWER ADAPTOR
BATTERY HOLDER
This appliance is only for use with the type of gas indicated on
the rating plate in this appliance and may be installed in an after-
market, permanently located, manufactured (mobile) home where
not prohibited by local codes. This appliance is not convertible for
use with other gases, unless a certified kit is used.
Do not operate the appliance with glass panel removed,
cracked or broken. Have a qualified technician replace a dam-
aged panel(s).
Improper installation, adjustment, alteration, service or mainte-
nance can cause property damage, personal injury or loss of
life. Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
Wiring
If any of the original wire as supplied with this unit must be re-
placed, it must be replaced with no. 18, 150°C wire or its equiva-
lent.
35919-4-1015
BLUE
BLUE
WHITE
ON/OFF
OR
SWITCH
(INCLUDED)
WHITE
GREEN
BLACK
RED
BLACK
RED
CAUTION
WARNING
GREEN
ORANGE
YELLOW
GAS CONTROL
VALVE
(GND)
PILOT
ORANGE
WHITE
ELECTRONIC
CONTROL MODULE
Page 39