I Mb-75 Installation - Icom IC-M603 Instruction Manual

I MB-75 installation

An optional MB-75
FLUSH MOUNT KIT
the transceiver to a flat surface such as an instrument panel.
CAUTION: KEEP the transceiver and microphone at least
1 meter away from your vessel's magnetic navigation com-
pass.
q Using the attached template, carefully cut a hole into the
instrument panel (or wherever you plan to mount the trans-
ceiver).
w Slide the transceiver through the hole as shown below.
e Attach the 2 supplied bolts (M5 × 8 mm) on either side of
the IC-M603.
is available for mounting
CONNECTIONS AND MAINTENANCE
r Attach the clamps on either side of the IC-M603.
• Make sure that the clamps align parallel to the IC-M603's body.
Supplied bolt
Clamp
t Tighten the end bolts on the clamps (rotate clockwise) so
that the clamps press firmly against the inside of the in-
strument control panel.
y Tighten the locking nuts (rotate counterclockwise) so that
the IC-M603 is securely mounted in position as below.
End bolt
t
u Connect the antenna and power cable, then return the in-
strument control panel to its original place.
9
y
Locking nut
9
49