Table of Contents
Advertisement
n MB-75 installation
An optional MB-75
flush mount kit
the transceiver to a flat surface such as an instrument panel.
CAUTION: KEEP the transceiver and microphone at least
1 meter away from your vessel's magnetic navigation
compass.
q Using the attached template, carefully cut a hole into
the instrument panel (or wherever you plan to mount the
transceiver).
w Slide the transceiver through the hole as shown below.
e Attach the 2 supplied bolts (M5 × 8 mm) on either side of
the IC-GM651.
is available for mounting
CONNECTIONS AND MAINTENANCE
r Attach the clamps on either side of the IC-GM651.
• Make sure that the clamps align parallel to the IC-GM651's body.
Supplied bolt
Clamp
t Tighten the end bolts on the clamps (rotate clockwise) so
that the clamps press firmly against the inside of the in-
strument control panel.
y Tighten the locking nuts (rotate counterclockwise) so that
the IC-GM651 is securely mounted in position as below.
End bolt
t
u Connect the antenna and power cable, then return the
instrument control panel to its original place.
8
y
Locking nut
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
115
Advertisement
Chapters
Table of Contents
