Yamaha 2004 YXR660 Service Manual page 222

MIDDLE GEAR
3. Install:
• shims 1
• bearing housing
NOTE:
Install the shims so that the tabs are positioned
as shown in the illustration.
4. Install:
• universal joint yoke
• washer
• nut 1
NOTE:
Use the universal joint holder 2 to hold the
yoke.
Universal joint yoke nut
150 Nm (15.0 m · kg, 110 ft · lb)
LOCTITE
Universal joint holder
P/N. YM-04062, 90890-04062
5. Install:
• universal joint
M MMM M MMM M M MMM M
a. Install the opposite yoke into the universal
joint.
b. Apply wheel bearing grease to the bearings.
c. Install the bearing 1 onto the yoke.
CAUTION:
Check each bearing. The needles can eas-
ily fall out of their races. Slide the yoke
back and forth on the bearings; the yoke
will not go all the way onto a bearing if a
needle is out of place.
4 - 96
ENG
®
M MMM M M MMM M M MMM M MMM