Yamaha 2004 YXR660 Service Manual page 431

Í Fasten the fuel hose and vacuum hose with the
plastic clip.
Î Make sure that the spark plug lead does not
contact the frame.
Ï The end of the spark plug cap boot must face
towards the passenger side of the vehicle.
Ð Fasten the final gear case breather hose with
the plastic holder.
Ñ Fasten the wire harness with the plastic band.
1
È
0
Ï
Ò
CABLE ROUTING
Ò Make sure that the plastic band is not fastened
too tightly around the wire harness.
Ó Pass the spark plug lead through the cutout in
the protective cover as shown.
Ô Fasten the rear brake pipe with the plastic band.
Õ Fasten the wire harness, speed sensor lead,
starter (choke) cable, starter motor lead, and
ground lead with the plastic band.
2
B
B
A
8
Î
9
Ð
Ñ
– 15 –
SPEC
Ó
3
É
9
Ê
A
4
5
Ë
6
Ì
Í
7
Õ
2
Ô
B-B