Recording A Memo; When Memory Is Full; Remote Access Code - AT&T 1815 User Manual

A N S W E R I N G S Y S T E M O P E R A T I O N

Recording a Memo

You can record a memo to be stored as an incoming message.
The memo can be up to 3 minutes long, and will be played back
with other messages.
Press and release M. After the beep, speak
1
toward the microphone.
To stop recording, press S.
2

When Memory is Full

The system can record approximately 12 minutes of messages,
including your announcement, for up to a total of 99 messages.
When memory is full, or 99 messages have been recorded, the
Message Window flashes F. Delete messages to make room for
new ones.
When memory is full, the system answers calls after 10 rings, and
sounds 2 beeps instead of playing your announcement.

Remote Access Code

You can use many features of this answering system remotely from
a touch tone phone. Most features can be accessed only after you
enter a Remote Access Code, preset to 500. You can view the
Remote Access Code by tapping c.
You can change the Remote Access Code to any 3-digit number
from 500-999.
Press and release g. The Message Window
1
displays CH.
Press and release c. The system announces "First
2
digit."
Press / or ? to change the digit.
3
4 When the Message Window displays the desired first
digit, press and release c. The system announces
"Second digit."
Press / or ? to change the digit.
5
6 When the Message Window displays the desired
second digit, press and release c. The system
announces "Third digit."
Press / or ? to change the digit.
7
8 When the Message Window displays the desired third
digit, press and release c. The system announces
the new Remote Access Code.