Installation - AT&T 1815 User Manual

At&t user manual tapeless digital answering system telephone with time/day 1815
Table of Contents

Advertisement

RING SELECT
POWER
Telephone Line Cord
FOR TABLE/DESK INSTALLATION
1
Install the batteries (optional).
Turn the unit upside down.
Push in on the two tabs at the large end of the base, and
lift the base off the unit.
Push in on the two tabs on the battery compartment
door, and remove it.
Insert four AA batteries. Always use four new batteries.
Replace the battery compartment door.
Reattach the base by inserting the tabs into the slots.
Push down on the large end of the base to lock it into
place. Make sure the larger end is toward the top of
the telephone. The telephone should sit flat on your
table or desk during use.
NOTE: The batteries provide backup power, allowing you to make
calls in case of a power failure. When battery power is low, the
LOW BATTERY light goes on. Replace the batteries promptly.
2
Connect the line cord to the telephone.
Plug one end of the line cord into the jack labeled TEL
LINE on the bottom of the telephone. Run the line cord
through the channel on the bottom of the phone.
I N S T A L L A T I O N
Battery Installation (optional)
3
Connect the handset to the telephone.
Plug the coiled cord into the handset jack on the side of
the phone. Plug the other end of the coiled cord into the
handset, then hang up.
4
Connect the line cord to a wall jack.
Plug the free end of the line cord into a telephone wall jack.
Make sure the cord snaps firmly into place.
5
Connect the power cord.
Use only the power cord supplied with your
system. If you need a replacement cord,
call 1 800 222–3111.
Fit the power cord behind the strain relief tab. Then, plug the
smaller end of the power cord into the POWER jack on the
back of the system. Plug the power cord into an electrical
outlet that is not controlled by a light switch. (When you
connect the system to power, the Message Window flashes
CL to indicate you need to set the clock. See "Setting the
Clock" in theAnswering System Operation section of this
manual.)

Advertisement

Table of Contents
loading

Table of Contents