Bowflex TC5300 Service Manual page 13

Use caution when connecting the wiring
harness to ensure that the wires do not
become pinched or come into contact
with any moving part. The TreadClimber®
fitness machine will not work and an
electric shock hazard may be present if
the wires become pinched.
2-7 Once the cable connection is made, slide the
brackets on the handlebar into the tops of the
upright tubes.
NoTE: Be careful not to crimp or cut the wire
at at any point during this step.
2-8 Attach each handlebar to the uprights using the
5/16 x 1 inch button head bolts (4 per handlebar)
and 5/16 inch washers.
2-9 Tighten the bolts using the 3/16 inch hex key.
Tighten the front bolt first, followed by the 3 bolts
on the inside of the uprights.
2-10 Recalibrate machine according to Appendix 3.
mechanical service guide
Figure 4:
Figure 5:
Figure 6:
Bowflex TreadClimber
®

Service Manual
®