Reset Smis-Configuration - HP P2000 G3 Cli Reference Manual

reset smis-configuration

Description Resets the SMI-S configuration files. For use by or with direction from a service technician.
This command will reset the configuration of the SMI-S service to default settings. After running this
command, any hosts registered via SMI-S will need to be registered again.
Messages are displayed when the SMI-S configuration is reset and SMI-S is restarted.
Syntax
reset smis-configuration
[a|b|both]
[prompt yes|no]
[noprompt]
Parameters a|b|both
Optional. The controller module containing the controller to restart. If this parameter is omitted, the
command affects the controller being accessed.
prompt yes|no
Optional. Specifies an automatic response to the confirmation prompt:
• yes: Allow the command to proceed.
• no: Cancel the command.
If this parameter is omitted, you must reply to the prompt.
noprompt
Optional in console format; required for XML API format. Suppresses the confirmation prompt, which
requires a yes or no response. Specifying this parameter allows the command to proceed without
user interaction.
Example Reset the SMI-S configuration on controller A, which you are logged in to:
# reset smis-configuration a
WARNING: The configuration of the SMIS service will be reset to default
settings.
you sure? yes
Info: SMIS service configuration has been reset for local controller.
(2013-01-10 16:53:51)
Success: Command completed successfully. (2013-01-10 16:53:51)
From controller A, reset the SMI-S configuration on controller B:
# reset smis-configuration b
WARNING: The configuration of the SMIS service will be reset to default
settings.
you sure? yes
Info: SMIS service configuration has been reset for partner controller.
(2013-01-10 16:55:08)
Success: Command completed successfully. (2013-01-10 16:55:08)
Any hosts registered via SMIS will need to be registered again. Are
Any hosts registered via SMIS will need to be registered again. Are
HP P2000 G3 MSA System CLI Reference Guide 121