MTD 500 series Shop Manual page 65

Thin Washer
Figure 6.22
E-ring
Figure 6.23
Thinest washer
Figure 6.24
Thick Washer
6.
NOTE: Keep track of the order of the washers for reas-
Bearing
7.
8.
9.
NOTE: The washer behind the Gear Set is the thinnest of
10. Slide the Friction Wheel Assembly off of the Hex
11. Repeat steps 6 through 9 on the opposite side of the
700 Series 3-Wheel Track-Drive System
Remove the bearing and washers.
sembly. See Figure 6.22.
Carefully remove the E-ring that secures the Plane-
tary Set. See Figure 6.23.
Slide the Planetary Gears Set off of the Hex Drive
Shaft.
Remove the washer that was behind the Gear Set.
the three washers. See Figure 6.24.
Drive Shaft.
Hex Drive Shaft.
61