MTD 500 series Shop Manual page 111

Discharge Chute and Controls (Joystick, Hex Shaft)
Cable ends
Figure 10.6
4. Attach the cables to the Cable Guide. See Figure
10.6.
5. Slide the Chute Deflector onto the Discharge Chute.
NOTE: Do not apply grease to the inside surface of the
Chute Deflector or the outside surface of the Dis-
charge Chute.
6. Install the carriage bolts and nuts that hold the Chute
Deflector to the Discharge Chute.
NOTE: Thread the nuts on to the carriage bolts until a cou-
ple of threads stick out past the nylon locking fea-
ture. Do not over tighten the nuts.
7. Install the screw that anchors the Cable Guide to the
Discharge Chute.
8. Test run the snow thrower in a safe area before
returning it to service.
107