MTD 500 series Shop Manual page 102

Medium Frame 2 & 3 Stage Snow Throwers
5. Slide the Cable Guide out from in between the
Cable Bracket and the Discharge Chute. See Figure
9.3.
6. Disconnect the cables from the Cable Guide.
7. Unhook the cable assembly from the Chute Deflec-
tor.
8. Mark one of the cables and its location in the Cable
Bracket. See Figure 9.4.
9. Remove both of the cables.
To install the Chute Deflector:
1. Hook the Cable Bracket onto the Chute Deflector.
2. Install both of the cables into the proper slots in the
Cable Bracket, as indicated by the arrows in Figure
9.5
NOTE: Forward movement of pitch control lever/
joystick should result in the Chute Deflector
moving down.
NOTE: If the cables are reversed, the chute opera-
tion will be reversed.
3. Insert the Cable Guide in between the Cable
Bracket and the chute.
98
Cable Bracket
Cable Guide
Figure 9.3
Mark the cable
and bracket
Figure 9.4
Figure 9.5