MTD 500 series Shop Manual page 128

Medium Frame 2 & 3 Stage Snow Throwers
5. Set the Chute Wiper in place.
6. Set the Chute Deflector on the chute.
7. Align the deflector and the chute by inserting a car-
riage bolt through the cute, wiper, deflector, Cable
Guide and the Cable Bracket. See Figure 11.13.
NOTE: Do not apply grease to the inside surface of
the Chute Deflector or the outside surface of
the Discharge Chute.
8. Install the nut on the carriage bolt installed in the
previous step.
NOTE: Thread the nuts on to the carriage bolts until
a couple of threads stick out past the nylon
locking feature. Do not over tighten the nuts.
9. Install the carriage bolt and wing nut on the left side
of the deflector.
10. Install the screw that anchors the Cable Guide to
the Discharge Chute.
11. Test run the snow thrower in a safe area before returning it to service.
124
Wiper
Figure 11.13
Carriage Bolt
Figure 11.14