Set Mode; I Set Mode Description - Icom IC-910H Instruction Manual

I Set mode description

Set mode is used for programming infrequently
changed values or conditions of functions. The
IC-910H has a regular set mode and additional 12 in-
dependent set modes for simple condition changing.
◊ Set mode operation
q Push [SET] for 1 sec. to enter the general set mode.
w Push [DN Z] or [UP Y] to select the desired item.
e Set the desired condition using the tuning dial.
• Push [M-CL 5] for 1 sec. to select a default condition or
value.
r Push [SET] to exit the set mode.
◊ Independent set mode operation
q Push [SET].
FM
S 1 3 5 7 9 20
FM
S 1 3 5 7 9
w Push 1 of following switches/keys to enter the inde-
pendent set mode.
[SPCH], [FM], [SSB/CW], [SCAN], [MPW], [COMP],
[VOX], [TRANSMIT], [NR], [RIT], [ATT], [SWP]
•SET MODE FLOW CHART
q
Push [SET] for 1 sec.
q
Push [SET] momentarily.
Push applicable key
VFO A
40 60dB 60dB
SET
VFO A
20 20 40 40 60dB 60dB
General set mode appears.
w
Independent

set mode

appears.
applicable
applicable keys
From The N3UJJ.COM Document Library From The N3UJJ.COM Document Library
e Push [DN Z] or [UP Y] to select the desired item.
r Set the desired condition using the tuning dial.
• Push [M-CL 5] for 1 sec. to select a default condition or
value.
SCAN
t Push the applicable switch, pushed in step w, or
[SET] to exit the set mode.
FM
S 1
w
Select set mode item. Select condition.
Tuning dial
e
Select set mode item. Select condition.
SET MODE
SCAN
VFO A
3 5 7 9 20 40 60dB 60dB
FM VFO A
S 1 3 5 7 9 20 20 40 40 60dB 60dB
e r
Exit set mode.
Push applicable
key or [SET] key.
r t
Exit set mode.
applicable
Tuning dial Push applicable
key or [SET] key.
10
SCAN
55