I Satellite Operation; I Satellite Memory - Icom IC-910H Instruction Manual

I Satellite operation

When your own signal can be received with a loop
test, satellite communication can be performed.
q Rotate the tuning dial to re-tune the uplink fre-
quency after pushing [SWP 0 Í], when shifting a
frequency with the Doppler effect.
• The downlink frequency readout (MAIN band) disap-
pears.
w Rotate the tuning dial to re-tune the downlink fre-
quency after pushing [SCAN . Â], when the oper-
ating station's signal frequency is shifted.
• RIT function can also be used for downlink frequency
tuning within ±1 kHz range.

I Satellite memory

The IC-910H has 10 satellite memory channels to
memorize both uplink and downlink frequencies and
operating modes, etc.
◊ Satellite memory selection
q Push [SATELLITE] to enter the satellite mode.
w Push [V/M 1] to select satellite memory mode.
• "MEMO" indicator and memory channel number are dis-
played beside the uplink frequency (SUB band) indica-
tion.
• Push [V/M 1] again to select satellite VFO.
e Push [DN M] or [L UP] to select the desired satel-
lite mode memory channel.
• The channels 00–09 are selectable.
• By pushing and holding either switch, the satellite mem-
ory channel changes continuously.
USB USB
S 1 3 5 7 9 20 40
LSB
NOR
SATL
S 1 3 5 7 9 20 20
60dB
MEMO
40 40 60dB 60dB
Satellite memory
indication
From The N3UJJ.COM Document Library From The N3UJJ.COM Document Library
SATELLITE OPERATION
◊ Satellite memory programming
q Select the desired satellite memory channel.
• Push [SATELLITE] to enter the satellite mode.
• Push [V/M 1] to select satellite VFO mode.
• Push [DN M] or [L UP] to select the desired satellite
mode memory channel.
w Set the desired downlink frequency to the MAIN
band and uplink frequency to the SUB band, as well
as operating mode.
• Push [SCAN . Â] for downlink tuning, push [SWP 0 Í]
for uplink frequency tuning.
• Push [SUB] before the operating mode selection when
selecting operating mode for the uplink.
e Push [MW 4] for 1 sec. to program the set contents
to the satellite memory channel.
• 3 beep tones sound.
NOTE: Tracking selection, normal or reverse, is not
programmed in the satellite memory channels.
USB USB
S 1 3 5 7 9 20
LSB
SATL
RE V
S 1 3 5 7 9
40 60dB
MEMO
20 20 40 40 60dB 60dB
Select the desired
satellite memory
8
51