JVC MX-G500 Service Manual page 14

MX-G500
<CD mechanism section>
Removing the CD mechanism holder from the CD
•
chager unit.
(Refer to "Removing the CD mechanism holder
assembly" )
Removing the pickup unit
1. Removing the cut washer on the feed gear
sleeve and pull out the feed gear.
2. Remove the two screws A fixing the pickup
shaft.
3. Removing the pickup unit.
Removing the motor board
1. Unsolder the motor terminal on the motor board.
2. Remove the moter board.
Removing the feed motor
Remove the two motor fixing screws at B and
removing the feed motor.
Removing the spindle motor
The spindle motor cannot be removed as a single
unit.
When removing the spindle motor, change the chasis
and turntable together as aunit.
1-14
(
See Fig.1)
(See Fig.2)
(
See Fig.1)
Motor board
Spindle motor
Shutter
Pickup unit
A
Cut washer
B
Fig.1
Unsolder Feed motor
Unsolder
Fig.2
Shaft
A
Feed Gear