Ground Connection - HP R/T2200 G4 NA/JP User Manual

3. Installation
HP R/T3000 G4 HV NA/JP and R/T3000 G4 INTL UPS
Check that the indications on the name plate located on the back of the UPS correspond to the AC-power source and the
true electrical consumption of the total load.
The UPS charges the battery as soon as it is connected to the AC power source, even if the
is not pressed.
After the UPS is connected to the AC power source, eight hours of charging is required before the battery can
supply the rated backup time.

3.7 Ground connection

Page 21
10
8
9
7
32 35
1. Connect the
supplied cable 31 (250V -
10
16A) to the socke
to the AC-power source.
2. Connect the loads to the UPS using the
9
32
cables .
It is preferable to connect the
priority loads to the four outlets marked
31
and the non-priority loads to the four outlets
marked 8 that can be programmed in pairs
(1 and 2).
For the R/T3000 G4 HV NA/JP HV and R/T3000
G4 INTL models, connect any high-power
devices to the 16A outlet
3. To program shutdown of outlets
operation on battery power and thus opti-
mise the available backup time,
please check the in/out settings.
4. Fit the connection securing system
prevents the plugs from being pulled out acci-
dentally.
, then
9
7
.
8
during
35 that
button
792519-001 Edition 1