Installing The Cover - IBM eServer 135 xSeries User Reference Manual

Installing the cover

56
IBM xSeries 135: User's Reference
The following information describes the cover installation procedure.
Complete the following to install the server cover:
1. Clear any cables that might impede the replacement of the clear shield or the
cover.
2. Install the clear shield, if it was removed.
3. Install the cover by placing it into position and sliding it forward. Make sure that
the cover engages the tabs at the front and rear of the server.
Important
Before sliding the cover forward, make sure that all of the tabs on the cover
will engage the ledge at the front of the server properly. If all the tabs do not
engage the ledge properly, it will be extremely difficult to remove the cover
later.
4. Install the screws and secure the cover as shown.
5. Reinstall the server in the rack.
6. Reconnect the power cord and all external cables to the server, then plug the
power cords into electrical outlets.
Screws