Replacing The Battery - IBM eServer 135 xSeries User Reference Manual

Table 18. NetWare driver messages for the Ethernet controller
Primary and secondary adapters do
not match. AFT group is not created.
Requested number of Secondary
cards are not found.
Failed to create AFT group. Make
sure that the drivers for supported
adapters are loaded, primary adapter
is bound to protocols, and secondary
adapter is not bound to any protocols.
Error identifying slot numbers for the
specified board names.
Can't unbind specified slot from AFT
group. Make sure that the slot you
specified is for the primary adapter in
an AFT group.
LAN adapter at slot nnnn (Port 0xaa)
failed to reset. Check the state of the
adapter.
AFT is not supported on this version
of NetWare.
Failed to allocate resources tags.
Please unload all LAN drivers before
unloading AFT.NLM.

Replacing the battery

98
IBM xSeries 135: User's Reference
Explanation: A bind command was entered for an adapter team that is a
combination of server and client adapters. An AFT team must be a grouping of
the same classification of adapter.
Action: Verify that all the adapters bound in a team are of the same
classification.
Explanation: The number of adapters specified in the bind command could
not be located.
Action: Verify the numbers and slot locations of the adapters to be bound. If
the problem persists, contact your network supplier.
Explanation: Binding of protocol failed. Protocol is either not bound to any
adapter or is bound to more than one adapter in the group.
Action: Ensure that the protocol is bound to only one adapter in an AFT team.
Explanation: The mapping between the board name entered and the slot
number for an adapter could not be established.
Action: Check the board name for the adapter before issuing the bind
command. If the problem persists, contact your network supplier.
Explanation: The number entered in the unbind command was not the
primary adapter in an AFT group.
Action: Reissue the unbind command and specify the slot number for the
primary adapter.
Explanation: The adapter that you specified could not be initialized.
Action:
1. Load the driver for the supported adapter.
2. Check that the adapter is seated properly in the slot and try loading the
AFT module again.
If the problem persists, contact your network supplier.
Explanation: The NetWare on your server is not a version supported by AFT.
Action: Load and bind AFT only on supported versions of NetWare (currently
version 4.11 and later).
Explanation: An unknown error has occurred when trying to allocate needed
resources for the AFT module.
Action: Check Server Configuration. If the problem persists, contact your
network supplier.
Explanation: An attempt was made to unload the AFT.NLM module before
unloading the adapter device driver.
Action: Unload the adapter driver before unloading the AFT module.
When replacing the battery you must replace it with a lithium battery of the same
type, from the same manufacturer. To avoid possible danger read and follow the
safety statement below.
To order replacement batteries, call 1-800-772-2227 within the United States, and 1-
800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call your
IBM reseller or IBM marketing representative.
Note: After you replace the battery, you must reconfigure your server and reset the
system date and time.