IBM eServer 135 xSeries User Reference Manual page 89

Table 12. POST error messages
POST message
01295085 The ECC checking hardware test failed.
Action:
01298001 No update data is available for processor 1.
Action:
01298101 The update data for processor 1 is incorrect.
Action:
I9990301 A hard disk drive error occurred.
Action:
I9990305 POST could not find an operating system.
Action:
If you cannot reinstall the operating system, call for service.
I9990650 AC power has been restored.
Action:
Other Numbers POST found an error.
Action:
Call for service.
Update the system BIOS to a level that supports the microprocessor that is installed
in the server.
Update the system BIOS to a level that supports the microprocessor that is installed
in the server.
Call for service.
Install an operating system. If you have already installed the operating system,
check the drive startup sequence. If the drive sequence is correct, run the diagnostic
tests to verify that the hard disk drive is functioning correctly. If there is a problem
with the hard disk drive (such as a bad sector), you might need to reinstall the
operating system.
No action is required. This message appears each time ac power is restored to the
server after an ac power loss.
Follow the instructions on the screen.
Description
Chapter 6. Solving Problems
77