E25 Assembly Instructions - SOLE E20 Owner's Manual

E25 ASSEMBLY INSTRUCTIONS

1
STABILIZERS & CONSOLE MAST
See Page 13 for Illustration
1. Connect the Front Stabilizer Bar (2) with the Main Frame at the front joining
plate by using the Wrench (151) to tighten two Hex Head Bolts (109) , two
Split Washers (142) and two Flat Washers (139).
2. Connect the Incline Rail Assembly (3) with the Main Frame at the front joining
plate by using the Wrench (151) to tighten two Hex Head Bolts (112) , two
Split Washers (142) and two Curved Washers (144).
3. Guide the Console Mast (15) through the Console Mast Cover (82), and then
guide the Computer Cable (38) through the Console Mast Cover (82) and
Console Mast (15). Then secure the mast on the Main Frame by using the
Wrench (151) to tighten the preinstalled Hex Head Bolt, three other Hex Head
Bolts (109 & 110), two Curved Washers (144) and one Split Washer (142).
4. Plug in the connectors of the Computer Cable (38), two Handpulse with
Cable Assemblies (White & Red) (44 & 45), Swing Arm Wire (Upper), Resis-
tance (48) and Swing Arm Wire (Upper), Incline (49) on the back of Console
Assembly (35) and secure the Console Assembly (35) on the console holding
plate with four Phillips Head Screws (119) by tightening them with Phillips
Head Screw Driver (150).
2
LOWER SWING ARMS
See Page 13 for Illustration
1. Attach the Lower Swing Arms (L) and (R), (12) and (13), on each side of
Console Mast shaft and secure with two Hex Head Bolts (104) and two Flat
Washers (138) by using the Wrench (152).
2. Insert the shaft of the left Connecting Arm (10) through the bushing on left
Pedal Arm (7) and secure with a Button Head Socket Bolt (115) together with
a Flat Washer (138) by using M5 L Allen Wrench (149). Repeat this process for
the right Connecting Arm (11) and right Pedal Arm (8).
3. Remove the Rod End Shaft (20), Flat Washer (136) and Hex Head Bolt (104)
which are on the left and right Connecting Arms. Connect the Connecting
Arm with the Lower Swing Arm and secure with Rod End Shaft (20), Flat
Washer (136) and the Hex Head Bolt (104) by using the Wrench provided
(152).
E20 / E25 ELLIPTICAL
12
HARDWARE STEP 1
#109. 3/8" x 2-1/4" Hex
Head Bolt (3 pcs)
#110. 3/8" x 3/4" Hex
Head Bolt (2 pcs)
#112. 3/8" x 3-3/4" Hex
Head Bolt (2 pcs)
#119. M5 x 10mm
Phillips Head Screw
(4 pcs)
#139. 3/8" x 19mm x
1.5T Flat Washer (2 pcs)
#142. 3/8" x 2T
Split Washer (5 pcs)
#144. 3/8" x 23 x 2T
Curved Washer (4 pcs)
HARDWARE STEP 2
#104. 5/16" x 15mm
Hex Head Bolt (2 pcs)
#115. 5/16" x 15mm
Button Head Socket Bolt
(2 pcs)
#138. Ø8.5 × 26mm ×
2.0T Flat Washer (4 pcs)