Summary of Contents for Blaupunkt San Francisco CD70
Page 1
Radio / CD San Francisco CD70 Operating instructions...
Page 2
Bitte aufklappen Open here Ouvrir s.v.p. Aprite la pagina Hier openslaan a.u.b. Öppna Por favor, abrir Favor abrir...
Page 4
CONTROLS button - opens the operating panel Button - switches the radio and mute function on/off Volume control Soft keys - the function of the soft keys depends on the current content of the display OK button - confirms menu entries and leaves the menu DSA button - selects the DSA menu Multifunction rocker switch...
Thank you for deciding in favour of a Blau- CD changer punkt product. We wish you a great deal of The following Blaupunkt CD changers can be pleasure with your new car radio. connected to the radio: CDC A 06, CDC A 08, CDC A 072 and IDC A 09.
THEFT PROTECTION Note: Theft protection, KeyCard If a wrong card, e.g. a cash card, is introduced A KeyCard is supplied along with the radio. into the car radio, “Wrong KC” will appear on the display. The car radio can also be used with a sec- Remove the wrong card and slide in a Key- ond KeyCard.
THEFT PROTECTION Hold down the TUNE button > and the Insert the new KeyCard. second soft key from the top on the left “LEARN OK” appears on the display. 4 at the same time; To leave the KeyCard menu, switch the unit on using button 2. press the MENU button 8 once or OK “0000”...
THEFT PROTECTION SWITCHING ON/OFF Displaying radio pass data Switching on/off With the KeyCard supplied with your car ra- There are various ways of switching the car dio, you can have the data on your radio pass, radio on and off. such as name, type number (7 6 ...) and seri- al number displayed.
USING YOUR CAR RADIO FOR THE FIRST TIME Using your car radio for the Set the minutes using the button first time Press the OK button 5. If the car radio is being connected for the first Setting the tuner time or the power supply to the unit has been interrupted, the install menu appears on the Press the soft key 4 with the display...
VOLUME Press the OK button 5 to go back to Volume adjustment the previous menu level or the MENU The system volume can be adjusted in steps button 8 to leave the menu altogether. from 0 (off) to 50 (maximum). The settings are now stored.
VOLUME AUDIO SETTINGS Setting the volume for the Audio settings warning tone (beep) Note: If you hold down a button for longer than two You can adjust the bass, treble and loudness seconds when using certain functions, e.g. settings separately for each audio source. storing a station on a station button, a warn- ing tone (beep) sounds.
AUDIO SETTINGS DISPLAY If you want to deactivate the loudness func- Setting the display tion, You can adjust the display to your needs and button 7. press the the position of the car radio in your vehicle. “LOUD OFF” appears on the display. Setting the reading angle When the settings have been completed, Press the MENU button 8.
RADIO MODE DISPLAY Display brightness - night Radio mode Press the MENU button 8. This unit is equipped with an RDS radio re- Press the soft key 4 with the display ceiver. Many of the receivable FM stations transmit a signal that not only carries the pro- allocation “DISP”.
RADIO MODE Switching the RDS function on/off Selecting the wavelength To use the RDS functions AF and REG, To select the wavelength, FM, MW or LW, press the TUNE button > when in radio press the TUNE button > when in radio mode.
RADIO MODE To return to the basic radio menu, Tuning into stations manually press the TUNE button > or wait 8 sec- You can also tune into stations manually. onds. The settings are now stored. button 7. Press either the Setting the sensitivity of the Note: station search mode...
RADIO MODE Listening to preset stations The display shows the currently set value for sensitivity. “DX 3” denotes maximum sensi- Select the memory or frequency range tivity for long-range reception. “DX 1” is the in which the station was stored. minimum.
RADIO MODE lights up alongside the scanned memory po- tion of the selected programme type is re- sition. ceived, the unit automatically switches from the current station, CD or CD changer mode Ending SCAN, continuing to listen to a to the station with the selected programme station type.
RADIO MODE Optimising radio reception Note: If no station corresponding to the selected High-frequency cut-off feature (HICUT) programme type is found, “NO PTY” appears briefly on the display. The unit then tunes in The HiCut function improves the sound dur- automatically to the station last received.
RADIO MODE Press the soft key 4 with the display Interference-related wavelength change (SHARX) allocation “MONO”. With the SHARX function you can eliminate The current status “MONO” or “STEREO” interference from neighbouring stations al- appears briefly on the display. When mono is most completely.
RADIO MODE Naming a station Select the station name you would like to clear by pressing the soft key 4 with You have the option of giving a preset station the display allocation “PREV” or “NEXT” a four-digit name to appear on the display. for the previous or next preset station on Press the MENU button 8.
TRAFFIC INFORMATION Setting the traffic announcement Traffic information volume Your car radio is equipped with an RDS-EON Press the MENU button 8. reception system. EON (Enhanced Other Network) stands for Press the soft key 4 with the display the broadcasting of station information within allocation “VAR”.
Press the button on the open operat- CDs) can be played, but due to differences in ing panel. CD quality, Blaupunkt cannot vouch for per- The CD is ejected. fect performance. Carefully remover the CD. Rewritable CDs (CD-RWs) cannot be played on this unit.
CD MODE Traffic announcements in CD “SCAN” appears briefly on the display. The CD tracks are played in ascending order. mode If you want to receive traffic announcements Note: whilst listening to a CD, The scanning time is adjustable. Read about Press the soft key 4 with the display setting the scanning time in the section “Set- ting the scanning time”...
CD MODE The current TPM status (“TPM ON” or “TPM This brings you to the edit mode. If the CD OFF”) appears briefly on the display. When you have selected is not yet known to the unit, playback of favourite tracks is active, an ar- eight underlines will appear on the display.
To find out which CD changer is compatible until the fast search backwards or for- with this unit, please see page 41 of this ma- wards begins. nual or consult your Blaupunkt dealer. Changing the display Note: Information on handling CDs, inserting CDs...
CD CHANGER MODE Scanning all tracks on all CDs Stopping REPEAT (SCAN) To stop the repeat function for the current track or CD, To listen in briefly to all the tracks on all in- press the soft key 4 with the display serted CDs in ascending order, allocation “RPT”...
CD CHANGER MODE Press the OK button 5 to return to the This brings you to the edit mode. If the CD you have selected is not yet known to the unit, previous menu level or the MENU but- ton 8 to leave the menu altogether. seven underlines appear on the display and the current input position flashes.
CD CHANGER MODE CLOCK Clearing preset of tracks CLOCK - Time In order to clear individual tracks from the list Setting the time of favourite tracks for a CD, switch on TPM; The time can be set automatically using the RDS signal.
Page 30
CLOCK Viewing the clock even when car Setting the time manually radio is switched off To set the time manually, press the MENU button 8; To view the clock when the car radio is switched off and the ignition is switched on, press the soft key 4 with the display press the MENU button 8;...
DSA - DIGITAL SOUND ADJUSTMENT Lining up the equaliser DSA - Digital Sound automatically Adjustment You can line up the equalisers electronically This unit is equipped with a digital sound-ad- for three different situations, and store these justment system. This consists of three self- settings, e.g.: aligning, adaptable 7-band equalisers, a dy- EQ 1 for the driver alone...
DSA - DIGITAL SOUND ADJUSTMENT Selecting an equaliser Setting the equalisers manually After automatic or manual line-up, We recommend you use a CD you are famil- iar with when adjusting the equaliser. press the DSA button 6; Before adjusting the equaliser, set the tone select one of the equalisers EQ1, EQ2 and volume balance to zero and deactivate button 7;...
DSA - DIGITAL SOUND ADJUSTMENT Setting aid for the equaliser Sound impression/problem What to do Bass reproduction too weak Raise bass with frequency: 64 to 160 Hz, level: +4 up to +6 dB Impure bass Reduce lower mid-section with Booming frequency: 400 Hz, Disagreeable pressure level: approx.
We recommend the use of matching prod- via TMC and can therefore by used by suita- ucts from the Blaupunkt or Velocity ranges. ble navigation systems for route planning. Your car radio has one TMC output for connection Switch-on delay for external pre- to Blaupunkt navigation systems.
SUBOUT/SUBWOOFER HIGH-PASS FILTER Subout/subwoofer High-pass filter Setting the frequency and level Setting the high-pass filter for the subwoofer If a subwoofer is connected to your car radio, you can use a high-pass filter (HP-F) to sup- You can set the frequency and amplifier level press the output of lower frequencies through for a connected subwoofer.
The AUX output has to be switched on in the power install menu. To connect up an external audio source, you will need an adapter cable, obtainable from Tuner any Blaupunkt dealer. Frequency ranges: Switching the AUX input on/off FM : 87,5 – 108 MHz MW : 531 –...