Operation Panel Tests - Canon FAX-L380S Series Service Manual

6-3 SENSOR
[ 1]---[ 4]
Pressing the 1 button
DS of DES of DOC A4
DS : Document sensor on/of
DES : Document edge sensor on/of
DOC : Not used
Pressing the 2 button
CT1 on MF of TOP of
PE of OF of CVR of
CT1 : Cassette recording paper sensor on/of
MF : Manual paper feed sensor on/of
TOP : Paper leading edge sensor (Top sensor) on/of
PE : Paper delivery sensor on/of
OF : Paper full sensor on/of
CVR : Front cover switch on/of
Pressing the 3 button
CRG of TN on 0127
OV of JAM of
CRG : Cartridge sensor on/of
TN : Toner sensor on/of and toner amount
OV : Paper full sensor (status via DCNT board) on/of
JAM : Paper delivery jam detection on/of
Pressing the 4 button
PANEL on
PANEL : One-touch cover sensor on/of
F-5-28

5.5.11.6.3 Operation panel tests

/ FAX-L390 / / / FAX-L380S
The operation panel test is selected by pressing the numeric button 7 from the faculty test menu.
In this test, check that the display, LED lamps and buttons on the operation panel are operating correctly.
Display test
Pressing the Start button from the operation panel menu, "H" is displayed 20 characters by 2 lines. The next time the Start button is pressed, all the LCD
dots are displayed. Check for any LCD dots in the display that are not displayed.
LED lamp test
All the lamps on the operation panel light by pressing the Start button after the display test. Check for any LED that does not blink during the test.
Operation button test
The One-touch speed dialing button test is selected by pressing the Start button after the LED lamp test. In this test, the letters a-t are displayed on the
display, corresponding to one-touch speed dialing buttons 01-20. Each letter displayed on the display goes out when its corresponding one-touch speed
dialing button is pressed. In this test, check for one-touch speed dialing buttons whose corresponding letter does not go out when the button is pressed.
When all the letters displayed have gone out, the system next starts the Operation button test. In this test, you press the button corresponding to the
displayed character to put it out. The table giving the correspondence between the characters and the buttons is below. In this test, check for operation
buttons whose corresponding character does not go out when the button is pressed.
Character Operation button
0-9,*,# Numeric buttons
A Cursor button (-)
B OK button
C Cursor button (+)
D Enlarge/Reduce button
E Exposure button
F Image quality button
G Menu button
T-5-39
Character Operation button
J Energy saver button
K Stop/Reset button
L Start button
M Redial/Pause button
N Coded dial button
O Directory button
F Hook button
G COPY button
Chapter 5
0011-5294
5-35