Table of Contents
Advertisement
All-Call or Zone Paging
All-call paging sends the announcement through all the telephone speakers. Zone
paging sounds only over the telephones in a specific area.
To Use:
1. Lift handset.
2. Press ITCM
3. Dial 87 for all-call or 84, 85 or 86 for zones 1, 2 or 3
4. Make announcement
5. Stay on line if waiting for a reply ("meet-me" page) or hang up to end.
To Reply to a "Meet-Me" Page:
1. Lift the handset of any telephone
2. Press ITCM
3. Dial 88 to connect with the paging party.
Adjusting Volume Control
Your phone's volume control sets volume for the ringer, speaker, handset, headset
and group listening.
Ringer Volume
There are four ringer volume levels (ringer off may be installed as well). While your
phone is idle, press VOLUME UP or VOLUME DOWN to adjust.
Speaker Volume
There are eight speaker volume levels. Set them for the current call by pressing
VOLUME UP or VOLUME DOWN to adjust.
Handset Volume
There are either eight or 13 volume levels for handset volume (depending on
whether or not the installer sets the station for a hard of hearing user). To set level
for the current call, while on a call press VOLUME UP or VOLUME DOWN.
Headset Volume
There are 13 volume levels for headset volume. To set level for the current call,
while on a call press VOLUME UP or VOLUME DOWN.
Group Listening Volume
There are eight volume levels for group listening. While on a call, press VOLUME UP
or VOLUME DOWN to adjust.
Default volume settings for speaker, headset, handset and group listening may be
set by following these steps:
1. Press ITCM
2. Choose speaker, headset, handset or group listen mode to be affected
3. Press VOLUME UP or VOLUME DOWN to adjust
4. Dial "**5" (or "**7", depending on your phone system's setup) to save the
volume setting for future calls.
5. Repeat for each mode.
Courtesy of Main Resource, Inc. Visit us at
www.MainResource.com
for all your Comdial needs.
Page 15 of 27
or call 800 362-6740
Advertisement
Table of Contents
