Table of Contents
Advertisement
Use wrap-up mode when you need time to finish paperwork after a call. Program a
Do Not Disturb button.
Use off-duty mode:
1. Press OPTIONS
2. Press NEXT twice
3. Press DND
4. Press ON
5. Press SPKR to end.
To cancel, repeat steps 1-5 above, but press OFF instead of ON in step four.
Use wrap-up mode:
Press HOLD
•
Press programmed DND feature button.
•
To cancel, repeat.
Moving Your Telephone (when enabled)
When you move your telephone to another location, a display prompt will ask if you
would like to keep your previous programming or use the programming already set
at the new location.
To keep your old location's programming features and extension number, connect
the telephone line cord to the new jack. Do nothing until the HOLD light stops
flashing. Your new location now assumes the features from the previous location.
To assume the new extension number and programming features from the new
location, connect the telephone line cord to the new jack and press "#" while the
HOLD light is flashing.
Paging
Check with your administrator to determine what type of paging your system uses
and how to access it.
External Paging Units
Access the external paging unit by pressing a line button or dialing a code. The
announcement will be transmitted over the external speaker unit.
To Use:
1. Lift handset
2. Press ITCM
3. Dial the extension number of the station equipped for paging or press the
paging button programmed by the installer or dial "89".
4. Make announcement.
5. Hang up to end.
Courtesy of Main Resource, Inc. Visit us at
www.MainResource.com
for all your Comdial needs.
Page 14 of 27
or call 800 362-6740
Advertisement
Table of Contents
