Page 1
COMDlAL Solo II User’s TeleDhone Guide :’ This publication is applicable for the following Solo II Telephone models: 5531 -xx Manufacturing Code REV E and Later 5531 S-xx Manufacturing Code REV F and Later 5432X-xx Manufacturing Code REV A and Later 15432S-xx Manufacturing Code REV A and Later...
Basic Operation BASIC OPEl?ATlON PLACING A CALL On Hook Press line key. Listen for dial tone. Dial number. Lift handset when party answers. Hang up handset to end call. Off Hook Lift handset. Press line key. (This step is not necessary if idle line preference has been assigned to station.)
Basic Operation ABANDON HOLD DETECTION - If a distant party hangs up and the host system provides disconnect supervision, the holding station will: Drop line from hold condition Turn off tine status indicator PLACING INTERCOM CALLS Voice Announcing Lift handset. Press ITCM.
Basic Operation CONFERENCE CALLS Multiline Conference for 2 external parties and 1 internal party NOTE: Conference transmission levels are not com- pensated and connections of parties must be super- vised by one inside party. Establish first outside call and press HOLD. Establish second outside call.
Feature Operation FEATURE OPERATION LINE MONITORING Handsfree dial a number, Press line key. Dial number. Monitor call ringing. Lift handset when party answers. To activate line monitoring while on a call, Press MONITOR. . Hang up handset. places you on hold. You NOTE: Useful when a pafly can monitor...
Feature Operation line preference is busy or unavailable, press a line key and make the auto dial selection again. To program numbers, Press ITCM. Press SAVE. Listen for tone. Press desired key (in memory key field) autodial ltc&ons l-20 (level 1). Tone will stop. Press HOLD key, then memory key for auto dial locations 21-40 (level 2).
Page 10
Feature Operation REDIALING Saved Number Redial lhe last number dialed can be saved for redial at anytime. To save number, 0 Press SAVE, during or after the call. To dial saved number, Press HOLD key. Press SAVE key. When party answers, Lift handset.
Feature Operation If on line listening to busy tone or no answer, Press REDIAL key twice. If using handset, pause a few seconds and hang -OR- If using speakerphone, station will automatically hang up. Station will redial number once a minute for IO minutes.
Feature Operation If your system has been configured for recall, Press TAP to disconnect (as if you had hung up), and obtain a new dial tone for another call. NOTE: System can be configured for recall or tap, but not for both. POSITIVE DISCONNECT/RECALL If the hookswitch in the handset cradle is pressed...
Feature Operation MUTE To prevent other party from hearing, Press MUTE (monitor light flutters). Press MUTE again resume conversation (monitor light turns off). MESSAGE WAITING For internal system messaging, the message betweenSolo stations, waiting light of one sta- tion is controlled by another station designated as the Message...
Feature Operation STATION DIRECTORY A pull-out shelf contains a paper station direc- tory card which can be used to store identifica- tions as follows: Level 2 autodial identification for locations 21-40. Speed dial identification locations for locations 1-O. NOTE: The identification for the level 1 auto dial loca- tions l-20 should...
OPTIONS SPEAKERPHONE OPERATION NOTE: A speakerphone can be identified by the microphone opening on the front right-hand edge of the housing (refer to the illustration provided in the front of this manual). PLACING A CALL Press line key. Dial number or press memory key. When party answers, Speak toward the station.
Page 16
SUffiiienttY for the purchasefs purposes. contact Comdiil, Customer Service Department, P.O. Box 7266, Chorlottesvllle, VA 22906. COMDIAL Charlottesville, Virginia 22906-7266 Printed in U.S.A. 70-l 22.01...