Select Fan Setting (On/Auto/Circ); Clean Screen; Maintenance Reminders - Aprilaire 8800 Universal Owner's Manual

OpERATION
SElECT fAN SETTING
When the fan mode is changed during a program event
it remains in that mode until the next event starts . The
fan must be programmed to FAn on in the schedule to
run continuously through all events .
press [fAN] to select:
ON: Fan runs continuously. Use this mode for maximum
air circulation/cleaning .
AUTO: Fan runs only when the heating or cooling
system is on .
CIRC: Same as AUTo, but ensures the fan is on for at
least 20 minutes per hour . Use this mode for a balance
of energy savings and air circulation/cleaning .
press [DONE] to save and exit, or [CANCEl] to exit
without saving . The thermostat will save and exit if
nothing is pressed within 10 seconds .
61000762A 8800 Tstat Owners.indd 7
(ON/AUTO/CIRC)

ClEAN SCREEN

press [MENU] to enter the main menu .
press [ClEAN SCREEN] to disable the touch screen
for 30 seconds for cleaning .
Note: Use a soft damp cloth to clean the screen . Use
water or household glass cleaner. Do not spray liquids
directly on the screen .

MAINTENANCE REMINDERS

Maintenance reminders are set up by the installer to
indicate when the equipment is due for service. if a
maintenance reminder is displayed, call your HVAC
dealer for service . They can be cleared by pressing
[MENU] to enter the main menu, then [Next] to clear
each reminder .
7
3/28/11 4:20:01 PM