Programming Instructions - Cornelius MILLENNIUM MJ41-6PB Installation & Service Manual

Programming Portion Control (optional)
a.
Simultaneously, press and hold "S" (small) and "XL" (extra large) push button switches on the Coded
Autoset Portion Control Module until the LED light in the lower right hand corner of the module starts
blinking. Release the switches. The blinking LED indicates the programming mode is active.
b.
Place the cup under the white mixing valve nozzle and push the selected size button (small, medium,
large, or extra large). Hold the button in until the cup fills to the desired portion, then release the
button. Repeat the above procedure for the remaining sizes.
c.
After programming all the drink sizes, press and release the "cancel/pour"
Coded Autoset Portion Control to the operational mode. The blinking LED light will go out.
d.
If at a future date, it is decided to change the portion size of the drinks, the individual sizes can be
adjusted by the above procedure. It is not necessary to reprogram every size.
NOTE: The portion control has a full memory retention in case of a power failure.
CANCEL/POUR :
a.
Push and release cancel/pour button to stop the valve from dispensing.
b.
Push and hold for a continuous pour.
SMALL MEDIUM
S
M
CANCEL/POUR
LARGE EXTRA-LARGE
L XL
6
switch to return the
L.E.D.