Table of Contents
Advertisement
>HANDSET LOCATOR
DISPLAY BASE ID
>DISPLAY BASE ID
DIAL TYPE
DIAL TYPE
TONE
Telephone Operation
Base settings
Handset Locator
This feature is used as an aid to locate the handset(s).
It can only be activated from the base. Press
and then press the
MENU
HANDSET LOCATOR option is shown. Press
. The screen on the base will show
SELECT/MENU
PAGING ALL HANDSETS and start the paging tone
at the handset(s) for 60 seconds.
To stop the paging tone, press
press any dial pad key on the handset or press
on the base.
NOTE: The handset ringer volume also determines the level of the pag-
ing tone. If the handset ringer volume level is set to off (0), that handset will
be silenced for all calls and paging (see page 17).
Display Base ID
Press
SELECT/MENU
until the DISPLAY BASE ID option is shown. Press
to show the base ID number. This num-
SELECT/MENU
ber can be used when adding, replacing, or re-registering
handsets (see page 46-48).
Dial Type
At this menu you can choose Tone or Pulse dialing. The
factory default setting is
only if you do not have touch-tone dialing service.
^V
Use the
buttons to select
press
SELECT/MENU
NOTE: This sets the dial type for both the handset(s) and the base.
21
^
V
or
key until the
,
PHONE
and then press the
. Change this to
TONE
TONE
to save your preference.
SELECT/
or
SPEAKER
CLEAR
^
V
or
key
PULSE
or
, then
PULSE
Advertisement
Table of Contents
