Accessories; Optional Accessories And Compatible Equipment - Lincoln Electric invertec v205-t Operator's Manual

C-1
OPTIONAL ACCESSORIES
AND COMPATIBLE EQUIPMENT
Factory Installed
Twist-Mate Cable Connectors
1 – standard for Ground Clamp
1 – Gas Pass through for Tig Torch
Strap Packet
Instruction Manual
Field Installed
K870 - Foot Amptrol tm
V205-T's Output Control is in the "REMOTE" position,
the foot Amptrol energizes the output and controls the
output remotely. The Foot Amptrol connects directly
to the 6 pin Amphenol.
K963-1 - Hand Amptrol
V205-T's Output Control is in the "Remote" position,
the hand Amptrol energizes the output and controls
the output remotely. The Hand Amptrol connects
directly to the 6 pin Amphenol.
K814 - Arc Start Switch - Energizes the output for
TIG welding if remote output control of the amperage
is not desired. It allows on/off TIG welding at the cur-
rent set by the Current Control on the control panel.
When using the Arc Start Switch set the Output
Control to the "LOCAL" position.
Magnum® PTA-9 and PTA-17 TIG Torches - The
following standard Magnum® TIG torches with one-
piece cable may be used with the Invertec V205-T.
• K1781-1 PTA-9 12.5 ft
• K1781-3 PTA-9 25 ft
• K1782-1 PTA-17 12.5 ft
• K1782-3 PTA-17 25 ft
NOTE: Each torch requires a Twist-Mate adapter,(one
is included with the machine). Collets, collet bodies,
and nozzles are not included and must be ordered
separately.

ACCESSORIES

for TIG welding. When the
tm for TIG welding. When the
medium back cap
medium back cap
long back cap
long back cap
V205-T AC/DC TIG
CABLE PLUGS
K852-70 - Cable Plug Kit for 1/0-2/0 cable. Attaches
to welding cable to provide quick disconnect from
machine.
Twist-Mate Torch Adapter K1622-1 - One is shipped
with the welder torch. If you do not care to interchange
this part between torches (one is required to connect
Magnum PTA-9 or PTA-17 TIG torches with one-piece
cable to the V205-T) you may order an additional
adapters. The quick connect plug provides connection
for both gas and welding current.
TIG Torch Parts Kits - Parts kits are available for the
PTA-9 and PTA-17 TIG torches. These kits include
back cap, collets, collet bodies, nozzles and tung-
stens.
Order KP507 for PTA-9 torches
Order KP508 for PTA-17 torches
See publication E12.150 for parts kits breakdown.
Cut Length Consumables - TIG welding filler metals
are available for welding stainless steel, mild steel,
aluminum and copper alloys. See publication C9.10.
C-1