Protocol Settings; Settings From The Control Panel - Canon imageRUNNER 105 Network Manual

Protocol Settings

You can specify the protocol settings for the machine using any of the following:
•
Control panel
•
NetSpot (Utility software provided with the machine)
•
Web browser (Remote UI)
IMPORTANT
•
When configuring the protocol settings for the first time, use the control panel of this
machine or NetSpot. After configuring protocol settings, you can change the content by
using a web browser (Remote UI).
•
With a machine other than the imageRUNNER 5000i, you can retain the security by
setting the range of IP addresses of computers that can obtain access to the machine.
Once you set the range of IP addresses of computers from which data (print job/I-fax)
can be sent to the machine, the machine rejects data sent from computers of which the
IP addresses are not allowed. Once you set the range of IP addresses of computers on
which items for the machine can be set or browsed, it is not possible to use a web
browser (Remote UI) on computers of which the IP addresses are not allowed; utility
software on the computers cannot be used to set or browse detailed information
concerning the machine. See step 21 in "TCP/IP Settings," on p. 3-4.
•
Some items cannot be set using NetSpot. For details about items that can be set with
NetSpot, see "Network Setting Items," on p. 9-3.
NOTE
•
For instructions on entering settings using NetSpot, see "Chapter 7 Using the Network
and Device Settings with NetSpot."
•
For instruction on entering settings using a web browser (Remote UI), see "Chapter 2
Functions of the Remote UI" in the Remote UI Guide.

Settings from the Control Panel

IMPORTANT
•
Settings specified from the control panel become effective after the machine is restarted
after the procedure.
•
For information on entering characters using the touch panel display, see "Chapter 1
Before You Start Using This Machine" in the Reference Guide.

Protocol Settings

3-3
3