Driving Jump Disassembly - Brother PR600II Service Manual

Main unit
4

Driving jump disassembly

1. Remove the 2 screws 1, and then remove the J differential lever 1, thrust
washer, and J slide lever assembly 2.
2. Remove the retaining ring E4, and then remove the J slide lever shaft 3
from the J slide lever.
3. Remove the retaining ring E4, and then remove the J differential lever 4
from the J link assembly.
4. Remove the J driving lever 5 and the spring
assembly.
5. Remove the screws 2, and then remove the J cushion pin and the J
cushion.
Start movie clip (CD-ROM version only)
Upper shaft unit
from the J base
S46
1
2 1
Retaining ring E4 3
4
Retaining ring E4
5
2
S46
2 - 45