6.8.14.1.2 Checking The Water Hardness Level; G 818, G 658, G 858; Table 6-74: G 818, G 658, G 858 Programming Flow Chart; Table 6-75: G 818, G 658, G 858 Programming Functions - Miele G 600 Series Technical Information

Technical Information

Table 6-74: G 818, G 658, G 858 Programming Flow Chart

6.8.14.1 Programming Mode
1. To access the Programming Mode open the dishwasher door and turn the
dishwasher off.
2. Press and hold program buttons 1 and 3 while turning the dishwasher on. A
blinking Salt light indicates successful accessing of the Programming Mode.
3. Use the program buttons 1 to 3 to toggle the selected function on or off.
4. To save: After selecting options, press program button 6 twice and turn off the
dishwasher.
Program button
1
2
3

Table 6-75: G 818, G 658, G 858 Programming Functions

1
If no buttons light up, the dishwasher is programmed for "without water softener". To change to
"with water softener" follow the steps in Service Mode 2 (Section 6.8.14.3).
2
Factory setting
6.8.14.1.1 Setting the Water Hardness Level
1. Measure the water hardness in grains per gallon (gpg).
2. Access Programming Mode.
3. Press program button 2 (should be flashing). If program button 2 is not flashing, Service
Mode 2 must be accessed and the dishwasher programmed to "with water softener".
4. Using Table 6-76 below, press the program button that corresponds to the water
hardness (e.g., for a water hardness of 10 gpg, press program button 4).
5. Once the button is pressed for the selected water hardness setting, program button 2 will
flash.
6. To save: Press program button 6 twice. Program button 6 flashing indicates successful
saving of data.
Water hardness (gpg)
1-5
6-7
8
9-11
12-14
15-16
17-21
22-24
24-31
32-70

Table 6-76: G 818, G 658, G 858 Water Hardness Settings

6.8.14.1.2 Checking the Water Hardness Level

1. Access Programming Mode.
2. Press program button 2. A program button (1 to 5) will light, indicating the current water
hardness setting. Match the lit button to Table 6-76. If a button does not light, press
Function
Heating
Water hardness setting
Water intake time
Program button 6
Not pressed
Not pressed
Not pressed
Not pressed
Not pressed
Pressed
Pressed
Pressed
Pressed
Pressed
130
Options Button light status
2
On Off
Off On
See Section
Flashing = 1 to 70 gpg
6.8.14.1.1
2
70 seconds Off = 70 seconds
100 seconds On = 100 seconds
Program button lit
1
2
3
4
5
1
2
3
4
5
G 600/G 800
1