Deleting Stored Fault Codes; Program Index; G 811, G 851, G 851 Plus, G 856, G 856 Plus; Table 6-11: G 848 Fault Code Chart - Miele G 600 Series Technical Information

G 600/G 800
Selector switch position
5 o'clock
6 o'clock
7 o'clock
8 o'clock
9 o'clock
10 o'clock

Table 6-11: G 848 Fault Code Chart

6.8.2.3.2

Deleting Stored Fault Codes

Access Programming Mode and turn the dishwasher off.
6.8.2.3.3

Program Index

1. Access Service Mode 2.
2. Turn the program selector switch to the 2 o'clock position. The Start light flashes.
3. Press the Start button once, then turn the program selector switch slowly clockwise until
the Start light lights up. The program selector switch position will determine the
corresponding program index, as shown in Table 6-12 below.
4. Turn the dishwasher off.
Selector switch position
1 o'clock
2 o'clock
3 o'clock

Table 6-12: G 848 Program Indices

6.8.3

G 811, G 851, G 851 Plus, G 856, G 856 Plus

(G 856 shown)
Enter Programming Mode
Enter Service Mode 1
Fault code Fault
Heating failure - heating circuit opened or
F04
defective electrical component in heating circuit
F05 Water drainage failure, heater pressure switch
Too few pulses at flow meter / start of water
F06
intake
Too few pulses at flow meter / end of water
F07
intake
F08 Water intake failure, heater level switch
Heater level switch not switching on at the end
F09
of thermal stops
Program index
P0
P1
P3
Programming Flow Chart
To access:
Water hardness settings
Extended drying 14 minutes
Extended water intake
To access:
Manual step mode
Component test program
89
Technical Information
Electronic version
EPLG 540
For future modifications
For future modifications