6.8.14.3.2 Deleting Stored Fault Codes; 6.8.14.3.3 Program Index; Table 6-79: G 818, G 658, G 858 Fault Codes; Table 6-80: G 818, G 658, G 858 Program Indices - Miele G 600 Series Technical Information

G 600/G 800
Program button 6
Pressed
Pressed
Pressed
Pressed
Pressed

Table 6-79: G 818, G 658, G 858 Fault Codes

1
All wash programs can be run, but the heating element will not function during the cycle.

6.8.14.3.2 Deleting Stored Fault Codes

1. Access Programming Mode.
2. Press program button 6 twice.
3. A flashing program button 6 indicates successful fault code deletion.
4. Turn off the dishwasher.

6.8.14.3.3 Program Index

1. Access Service Mode 2.
2. Press the flashing program button 5.
3. Press the flashing program button 2.
4. The lit program button (1 to 5) will determine the corresponding program index, as shown
in the program index chart (Table 6-80).
5.
Switch the dishwasher off.
Program button 1 - 5
1
2
3
4
5

Table 6-80: G 818, G 658, G 858 Program Indices

6.8.15 G 879
Enter Programming Mode
Enter Service Mode 1
Program button
Fault code and description
light
1 F05
2 F06
3 F07
4 F08
5 F09
Program index Electronic version
P0 EPLG 546
P1 For future modifications
P2 For future modifications
P3 For future modifications
P4 For future modifications
Programming Flow Chart
To access:
Water hardness settings
Heated drying
Temperature reduction (EPLG 501A only)
Extended water intake (EPLZ 530 only)
Buzzer (EPLZ 530 only)
To access:
Manual step mode
Component test program
133
Technical Information
Water drainage failure, heater level
switch
Too few pulses at flow meter / start of
water intake
Too few pulses at flow meter / end of
water intake
Water intake failure, heater level switch
Heater level switch not switching on at
the end of thermal stops