JVC KD-S580 Service Manual page 8

KD-S580
< CD mechanism section >
Removing the top cover
1. Remove the two screws A on each side of the body.
2. Lift the front side of the top cover and move the
cover backward to release the two joints a.
Removing the connector board
CAUTION: Before disconnecting the flexible wire
from the pickup, solder the short-circuit
point on the pickup. No observance of
this instruction may cause damage of
the pickup.
1. Remove the screw B fixing the connector board.
2. Solder the short-circuit point on the connector board.
Disconnect the flexible wire from the pickup.
3. Move the connector board in the direction of the
arrow to release the two joints b.
4. Unsolder the wire on the connector board if
necessary.
CAUTION: Unsolder the short-circuit point after
reassembling.
Flexible wire
Frame
1-8
(See Fig.1 and 2)
(See Fig.3 to 5)
B
Connector board
Fig.5
A
Top cover
A
Joints a
B
Connector board
Joints b
Flexible wire
Joints a
Fig.1
Top cover
Fig.2
DET switch
Short-circuit
Pickup
Fig.3
Short-circuit point
(Soldering)
Pickup
Fig.4
A