JVC KD-S580 Service Manual page 6

KD-S580
Removing the bottom cover
Prior to performing the following procedure, remove
the front panel assembly, the front chassis assembly
and the heat sink.
1. Turn over the body and release the two joints c the
two joints d and the joint e .
CAUTION: Do not damage the board when
releasing the joint e using a screwdriver.
Removing the rear panel
Prior to performing the following procedure, remove
the front panel assembly, the front chassis, the heat
sink and the bottom cover.
1. Remove the three screws C , the four screws D
and the screw E on the back of the body. Remove
the rear panel.
Removing the main board assembly
Prior to performing the following procedure, remove
the front panel assembly, the front chassis, the heat
sink, the rear panel and the bottom cover.
1. Remove the two screws F attaching the main
board assembly. Disconnect connector CN501 and
remove the main board assembly.
1-6
(See Fig.5, 6)
(See Fig.5, 6)
(See Fig.7)
C
F
(See Fig.8)
CN501
Bottom cover
Joint c
Joint e
Fig.5
Bottom cover
Joint c
Fig.6
Rear panel
D C
D
Fig.7
Main board assembly
Fig.8
Joint d
Joint d
Joint e
E
D
C
F