JVC KD-S580 Service Manual page 15

Removing the loading roller assembly
Prior to performing the following procedure, remove
the clamper assembly and the top plate assembly.
1. Push inward the loading roller assembly on the gear
side and detach it upward from the slot of the joint d'
of the lock arm rivet assembly.
Detach the loading roller assembly from the slot of
the joint e' of the lock arm rivet assembly.
The roller guide comes off the gear section of the
loading roller assembly.
Remove the roller guide and the washer from the
shaft of the loading roller assembly.
2. Remove the screw I attaching the lock arm rivet
assembly.
3. Push the shaft at the joint f' of the lock arm rivet
assembly inward to release the lock arm rivet
assembly from the slot of the slide plate. Extend the
lock arm rivet assembly outward and release the
joint g' from the boss of the chassis rivet assembly.
The roller guide springs on both sides come off.
CAUTION: When reassembling, reattach the left
and right roller guide springs to the lock
arm rivet assembly before reattaching
the lock arm rivet assembly to the
chassis rivet assembly. Make sure to fit
the part h' of the roller guide spring (L)
inside of the roller guide (Refer to
Fig.30).
Roller guide
Frame
Roller guide spring
Fig.30
(See Fig.27 to 29)
Washer
Roller shaft assembly
Loading roller
Roller guide
Washer
Loading roller assembly
Joint e'
Roller guide spring
Loading roller assembly
Lock arm rivet assembly
Loading roller assembly
Roller guide
spring
Part h'
Fig.28-1
I
Lock arm rivet assembly
Roller guide
Roller guide spring
Joint d'
Roller guide spring
Fig.27
Loading roller assembly
Roller guide
spring
Fig.28-2
Chassis rivet assembly
Boss
Slide plate
Roller guide spring
Joint f'
Part g'
Fig.29
KD-S580
1-15