Table of Contents
Advertisement
4.1 GETTING STARTED
Install software, Click Setup.exe for the RegCom-Pro Program. After installation is complete, run the program. The
following window will be loaded.
4.2 REGCOM-PRO PROGRAMMING
Select " REMOTE " Tab, The following page will appear:
Click on "Set Comport". If the RegCom-Pro is in the "Baudrate Detection" Mode then you can set any baud rate and the
RegCom-Pro will self configure. However if the RegCom-Pro is already set to a baud rate you must select the exact baud
rate and communication configuration in the RegCom-Pro for connection to occur. If the unit does not display "Con-
nected" then you have either entered the wrong baud rate or communication settings or a cable problem or the RegCom-
Pro not powered.
Once connected then click "Remote" and will display "Accessed" or will go back to "No Access" if the baud rate or cable
connection is not proper and will also go back to "Not Connected" so you can reset the communication settings.
RegCom-Pro POS / Cash Register Interface
Figure 6 : RegCom-Pro Program Main Page
Figure 7 : Remote Page
15
4. PROGRAMMING
Advertisement
Table of Contents
