Advertisement
Available languages
Available languages
3. Installing your child seat (rearward facing) in rear middle seat
3a
3b
3c
3e
3
2
4
IMPORTANT
– The child seat can be used with either a lap or a lap and
diagonal seat belt.
The larger the child the more upright the seat must be. To change the position
(if required) slide the support leg out until it engages in the desired position.
To slide the support leg in push the two support leg adjuster buttons and pull
(dia 3a)
up the support leg
Place the child seat rearward facing with the back of the child seat positioned
centrally between the driver and passenger seat.
Extend the footprop fully by pressing the two release Buttons.Make sure
that the footprop tether brackets are facing forwards and that the straps
are not twisted. Lower the footprop and adjust the height so that it is within
3d
Slide the loop ends of the tether straps between the front car seat and back
(dia 2d &
as shown
round the outside of the car seat and feed through the loops
3
seat
. Provisionally tighten the tether straps by pulling the loose ends
4
downwards
.
(dia
3b). Use the ruler printed on the back
Loop a tether strap around both the
front driver and passenger seat as
(dia
shown
If your car is equipped with a runner
loop on the seat runners, these may be
used as an alternative
IMPORTANT
straps using the Luggage loops
dia
2e). Bring the hook ends of the tether straps
3c).
(see detail
3d).
– Do not install the tether
2
. Snap
Advertisement
