Fixing The Pre-Treatment Solution (Heat Press) - Epson SureColor F2000 Series User Manual

3. Spray the pre-treatment solution evenly over an area larger than the target print area.
Note: Run a roller over the area after spraying for an even application of the pre-treatment solution.
4. Fix the pre-treatment solution with a heat press, if necessary.
Note: The T-shirt fibers must be pressed flat to produce even whiteness. If you use a heat tunnel to
fix the ink, use a heat press to fix the pre-treatment solution.
Parent topic:
Related references

Fixing the Pre-treatment Solution (Heat Press)

Related tasks
Diluting the Pre-treatment Solution
Fixing the Pre-treatment Solution (Heat Press)
If you are using a heat tunnel to fix the ink, you must use a heat press before printing to remove creases
from the T-shirt and to fix the pre-treatment solution. Always place a heat-resistant release sheet, such
as silicon paper, between the T-shirt and the heat press.
Note: Do not wet the T-shirt or leave it in a humid location for a long time after fixing the pre-treatment
solution, or White ink may absorb into the wet sections and cause unevenness in color. If the T-shirt is
left for an extended period of time in a humid location, press it for 5 to 10 seconds just before printing.
Pre-treating a T-shirt
34