Setting The Ch Level - Harman Kardon AVR 134 Owner's Manual

SETTING THE CH LEVEL

NOTE : Depending on the speaker settings ("N (None or No)"), some channels cannot be selected.
Adjusting the current channel level
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user's memory("CAL"),
not into preset memory ("REF 1", "REF 2")
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes. (For details, refer to "Adjusting each channel level with test tone" on page 21.)
1.
Press the ▲/▼ buttons to select the desired channel.
Example)
When selecting Dolby
Digital source's LFE
(Low Frequency
Extension)
3.
Repeat the above steps 1 and 2 to adjust each channel level.
2.
Press the ◀/▶ buttons to adjust the level of the
selected channel or program source's LFE as desired.
• The LFE level can be adjusted within the range of -10 ~ 0
dB and other channel levels within the range of -15 ~ +15
dB
• In general, we recommend the LFE level to be adjusted to
0 dB.(However, the recommended LFE level for some
early DTS software is -10 dB.) If the recommended levels
seem too high, lower setting as necessary.
40