Setting Up The Receiver - Harman Kardon BDS 275 Owner's Manual

BDS
1. Press and hold the source button for the main device the remote will be operating.
The button will light up, go dark and then light up again. Release the button.
2. Select the type of punch-through programming.
a) For "punch-through" channel control, press the Channel + button.
b) For "punch-through" transport control, press the Play button.
3. Press the Aux button. The original source button will flash to confirm operation.
You can repeat Step 1 – Step 3 for any of the remote's source buttons (Disc, Radio, etc.).
NOTE: "Punch-through" channel and transport commands will override the existing
commands for those buttons in the source modes you program.
To undo "punch-through" programming, follow the same steps as above, but press the
same source button in Step 1 and Step 3.
Erasing a Learned Code and Restoring the Original Button Code
1. Press and simultaneously hold down the Aux and Bookmark (Green) buttons on
the BDS remote control for at least three seconds. The BDS remote will enter the
learning mode after the Aux button LED turns on.
2. Press and release the remote control button that you want to erase. The Aux button's
LED will flash three times.
3. To erase other buttons, press the selected buttons.
4. To exit the erase mode, press Aux button.
Resetting the Remote to Factory Default Condition
1. Press and simultaneously hold down the Aux and Thumbnail (Yellow) buttons on the
BDS remote control for at least three seconds.
2. The Aux LED will flash three times and exit learn-erase mode. Note: By erasing all
learned codes, all of the BDS remote buttons will return to their original functions.
Controlling an Apple TV
If you have connected an Apple TV to the BDS receiver's HDMI 3 input, you can also use
the BDS remote to control an Apple TV that is streaming audio and video files stored
on your home network, or accessing media from an Internet service such as Netflix, as
shown in the illustration below.
Menu
Button
Cursor Left
Button
Play/Pause
Button
Left Button
Down
Button
Select any other input source to return the BDS remote to its normal operation.
Using the Remote After it is Programmed
Pressing the remote's Aux Input button will put the remote into the auxiliary-control mode,
and it will control the auxiliary component(s) via the codes you have programmed into it.
To switch the remote back to the BDS receiver-control mode from the auxiliary-control
mode, press any of the other Input buttons or the Home button.

Setting Up the Receiver

NOTE: The menu screens shown in this manual are for illustrative purposes and may
differ somewhat from the actual displays.
To set up your BDS receiver, you will use the remote to navigate through all of the on-
screen menus and to make selections from them.
Initial Setup
When you turn your BDS receiver on for the first time, the on-screen menu will display
the Initial Setup screen. The first screen lets you set the language you want the BDS
receiver to use.
After you set the language, press the OK button and the Initial Setup introduction screen
will appear.
Cursor Right Button
Play/Pause Button
OK Button
Up Button
Right Button
Preparing the Remote Control
and Setting Up the Receiver
Use the Cursor Up/Down buttons to navigate through the menu list. When an item is
highlighted, a border will appear around it.
To select a highlighted item, press the OK button. The screen will change depending
on your selection.
To return to the previous screen, press the Previous button.
Initial Setup
Please select which language you would like the
BDS menus to appear in.
Initial Setup
Welcome to the Harman Kardon BDS setup wizard.
Some simple information is needed to ensure you
get the best experience from your product.
You can adjust these settings later in addition to making
changes to more advanced settings by selecting 'Settings;'
from the Home menu.
Previous
Step 1/6
OK Next
Step 2/6
OK Next
15