Tape Recording; Output Level Trim Adjustment - Harman Kardon AVR35RDS User Manual

2. While the PTY is shown, press the
button & u
Preset Up/Down
scroll through the list of available PTY
types, as shown above. To simply search for
the next station transmitting any RDS data,
use the button
Preset Up/Down
until any RDS appears in the display.
3. Press and hold the button
RDS
t for one second until the tuner begins
to scan for the first station that has RDS
data matching the desired selection, and
acceptable signal strength for quality
reception.
4. The tuner will make one complete scan
of the entire FM band for stations that
match the desired PTY type and have
acceptable reception quality. If no such
station is found, the tuner will return to the
last FM station in use before the search.

Tape Recording

In normal operation, the audio or video
source selected for listening through the
AVR35RDS is sent to the record outputs.
This means that any program you are
watching or listening to may be recorded
simply by placing machines connected
to the outputs for
Tape Monitor
¢
in the record mode.
Video One
AVR35RDS 230 volt Rev (C) 9/28/98
Operation
When a tape recorder with separate record
to and playback heads is used, you may
monitor the output of the recording by
selecting the Tape Selector 9 l
Note that a red LED will illuminate in the
& u front panel above the
to remind you that you are listening to
the record playback instead of the actual
* input source being recorded.
NOTE: It is not possible to record the
output of Dolby Digital programs.
IMPORTANT NOTE: Please make cer-
tain that you are aware of the copyright
restrictions on any material you copy.
Unauthorized duplication of copyrighted
materials is prohibited.

Output Level Trim Adjustment

Normal output level adjustment for the
AVR35RDS is established using the Test
Tone, as outlined on page 19. In some
cases, however, it may be desirable to
adjust the output levels using program
material such as a test disc, or a selection
you are familiar with. Additionally, the
output level for the subwoofer may only
be adjusted using this procedure.
b
or
To adjust the output levels using pro-
gram material, first set the reference
volume for the front left/right channels
using the Volume Control Ù
you wish to vary the difference between
the left and right channels, use the
Balance Control 7
28
Once the reference level has been set,
press the
¯
. will appear in the
Display V
Tape Selector 9 press the
the
buttons
DO NOT use the volume control, as this
will alter the reference setting.
Once the change has been made, press
the
Selector
buttons
channel location that you wish to adjust.
To adjust the subwoofer level, press the
Selector
buttons
appears in the
Display V
Press the
of the desired channel appears in the
Main Information Display V
follow the instructions shown above to
adjust the level.
Repeat the procedure as needed until all
channels requiring adjustment have
been set. When all adjustments have
been made, the AVR35RDS will return to
normal operation when no adjustments
are made for five seconds.
. If
.
button
Channel Select
and note that
FRONT L L E V
Main Information
. To change the level, first
button ˜ , and then use
Set
buttons ¸ or the
⁄
Selector
h to raise or lower the level.
button ˜ and then press the
Set
buttons ¸ or the
⁄ / ¤
h to select the next output
buttons ¸ or the
⁄ / ¤
h until
S-WOOFER L E V
Main Information
.
button ˜ when the name
Set
, and
i
¤
/